-
Beschaltung nach ISO/IEC 11801, EN 50173Pin/Pair Assignment according to ISO/IEC 11801, EN 50173
S Schirmanschluss
weiß/whitegrün/green
weiß/whiteorange/orange
weiß/whiteblau/blue
weiß/whitebraun/brown
weiß/whitegrün/green
weiß/whiteorange/orange
weiß/whiteblau/blue
weiß/whitebraun/brown
HinweisBei cable sharing wird je ein Kabelverbinder auf der Seite A und der Seite B des 4-paarigen Installationskabels benötigt.
NoteCable sharing requires one cable coupler on side A as well as on side B of the 4 pair installation cable.
Cat.7 Kabelverbinder IP20Cat.7 Cable Connector IP20Montagehinweis / Mounting information
6791
/899
019
METZ CONNECT | Im Tal 2 | 78176 Blumberg | GermanyPhone +49 7702 533-0 | Fax +49 7702 533-433Vertrieb durch / Distributed by RIA CONNECT GmbH und / and BTR NETCOM GmbHMontageanleitung siehe / Mounting instruction see www.metz-connect.com
METZ CONNECT | Im Tal 2 | 78176 Blumberg | GermanyPhone +49 7702 533-0 | Fax +49 7702 533-433Vertrieb durch / Distributed by RIA CONNECT GmbH und / and BTR NETCOM GmbHMontageanleitung siehe / Mounting instruction see www.metz-connect.com
BeschaltungshinweisePin/Pair Assignment
-
Kunststoffmantel ca. 80 mm abisolieren.Remove about 80 mm of the plastic sheath.
Geflechtschirm zurücklegen ...Fold braided shield backwards ...
... und rundherum abschneiden.
... and cut it off all around.
Variante 1: Kabelkonfektion mit Adernpaar weiß/braun beginnend.Variante 2: Kabelkonfektion mit Adernpaar weiß/grün beginnend.Paarschirmfolie entsprechend der Variante 1 oder 2 einkerben und entfernen.Variant 1: Start cable preparation with wire pair white/brown.Variant 2: Start cable preparation with wire pair white/green.Cut the shield foil of the wire pairs in the length indicated for variant 1 or variant 2 and remove it.
1
2
Adern gemäß Beschaltungshinweis in die Klemmen einführen und mittels Anlegewerkzeug anschließen.Insert wires into the terminals according to the wiring diagram, and connect them by using the crimp tool.
5
Abdeckung aufrasten.Snap on the cover.
Kabelverlängerung.Cable lengthening.
Kabelzuführung von einer Seite.Cable feeding from one side.
3
Zum Anschluss weiterer Kabel wiederholen Sie die Kabelkonfek-tion und die Schritte 1 und 2.To connect further cables, repeat cable preparation procedures as above and then steps 1 and 2.
80 mm
Kabelaufteilung 1x8 auf 2x4. Ggf. von der Kabel kon fektion (siehe Bild Kabelkonfektion Variante 1 und Va rian te 2) abweichende Adernpaar- und Schirmlän gen beachten.Cable splitting 1x8 to 2x4. Respect if necessary different lengths for wire pairs and shield foil (see fig. cable preparation variant 1 and variant 2).
5 mm
ca. 30 mmca. 40 mm
ca.55 mm
Öffnen des GehäusesGehäusedeckel mittels Schraubendreher entriegeln und abnehmen.Opening the housingUse a screwdriver to unlatch the housing cover and remove it.
wei
ß/w
hite
br
aun/
brow
n
4
Bervor der Gehäusedeckel aufgerastet wird, je weils an den entsprechenden Seiten mit einer Zange die Halte rung-/en abtrennen.Remove the brackets on the respective sides with pliers before the housing cover is snapped on.
Zugentlastung und Schirmanschluss anbringen.Hinweis: Für eine optimale übertragungstechnische Perfor mance muß der Paarschirm direkt bis zum LSA-Klemmkontakt geführt werden.Connect strain relief and shield connection. Note: To obtain the optimum of transmission performance lead the pair shield directly up to the respective LSA terminal contact.
ca. 20 mm Variante 1 Variant 1
Variante 2 Variant 2
weiß/white braun/brown
weiß/white grün/green
weiß/whiteblau/blue
weiß/white orange
weiß/white orange
weiß/white blau/blue
weiß/white grün/green
weiß/white braun/brown
wei
ß/w
hite
bl
au/b
lue
wei
ß/w
hite
or
ange
wei
ß/w
hite
gr
ün/g
reen
METZ CONNECT | Im Tal 2 | 78176 Blumberg | GermanyPhone +49 7702 533-0 | Fax +49 7702 533-433Vertrieb durch / Distributed by RIA CONNECT GmbH und / and BTR NETCOM GmbHMontageanleitung siehe / Mounting instruction see www.metz-connect.com
METZ CONNECT | Im Tal 2 | 78176 Blumberg | GermanyPhone +49 7702 533-0 | Fax +49 7702 533-433Vertrieb durch / Distributed by RIA CONNECT GmbH und / and BTR NETCOM GmbHMontageanleitung siehe / Mounting instruction see www.metz-connect.com
KabelkonfektionCable Preparation
KabelmontageCable Connection
AnwendungsbeispieleApplication Examples